We suggest to disable the hardware flow control.
RouterBOARD serial port is configured to 115200bit/s, 8 data bits, 1 stop bit, no parity. The required cable is described in the Serial console manual. To do the above actions without loading the backup loader, push the button right after applying power to the device.įor RouterBOARD devices that feature a serial console connector, it is possible to access the RouterBOOT loader configuration menu. Note: If you hold the button before applying power, backup RouterBOOT will be used in addition to all the above actions.
Or Keep holding the button for 5 more seconds until until LED turns off, then release it to make the RouterBOARD look for Netinstall servers (total 15 seconds). Keep holding for 5 more seconds, LED turns solid, release now to turn on CAPs mode (total 10 seconds). Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration (total 5 seconds). RouterBOOT reset button has three functions: For upgrade instructions, follow the separate instructions in Manual:Bootloader upgrade RouterBOARD reset button It is only possible to upgrade the main RouterBOOT, so in case of failure, you can use the backup booter to start the device and downgrade the main loader. Sometimes the RouterBOOT receives firmware upgrades (see Changelog). It is also possible to use the backup booter by turning on the device, with the RESET button pushed. System routerboard settings set force-backup-booter=yes It is possible to call the backup loader with a configuration setting in RouterOS: By default, the main loader is used, but RouterBOARD devices also have a secondary (backup) bootloader, which can be used in case the main doesn't work.
0 kommentar(er)
